enable com internet services on this computer

Select an Authentication level of Connect to provide a good balance between security and system performance. This value will not be used byĪn IOM server if you set its authentication level individually using theĪpplication tab (see Setting Permissions per Application on That do not have a specific setting of their own. For DefaultĪuthentication Level, choose the value that is most appropriate for applications (which creates an AppID-based setting in the Windows registry). Not provide a specific value, either programmatically or on the Applications tab

Select Enable Distributed COM on this computer.ĬOM uses the Default Authentication Level when a client or server does Note: The dialog box might look slightly different than the illustration, depending on the version of Windows you are running and which Service Pack you have applied. Expand the Component Services folder,Įxpand the Computers folder, then right-click on My Computer and select Properties.

If you are using Windows XP, the Component Services dialog box appears.

If you are using Windows NT/2000, the Distributed COM Configuration Properties dialog box appears.

The dialog box that appears depends on the Windows operating system you are using:

Type dcomcnfg, as shown in the illustration.Ĭlick OK.

Perform the following steps on each machine:įrom the Windows Taskbar, click Start Run. To establish a DCOM session, you must ensure that DCOM is enabled on the server machine and on each client machine. Per Application on Windows XP / Server 2003Ĭonfiguring DCOM on Windows XP SP2 / Server 2003 SP1Ĭonfiguring COM/DCOM for Active Server Page AccessĪccessing a Local COM IOM Server from an Active Server PageĪccessing a Remote DCOM IOM Server from an Active Server PageĬreating a Metadata Configuration File in SAS Planning Your Server Configuration MetadataĬreating Metadata Using SAS Management ConsoleĮnabling DCOM on the Server and the Client

Enable com internet services on this computer